Formax FD 280-20 - Manual (Page 20)

16 6/10
2. Pull the FUSE DRAWER out of the POWER
ENTRY CASING. (Refer to Figure 7.1.)
Figure 7.1
– Replacing a Line Fuse
3. Inspect the FUSES; look for blackened glass,
melted wire or a disconnected wire between the
ends of the tube. If you find any of these
problems in either FUSE, that FUSE is blown and
must be replaced.
4. Pull the blown FUSE from its slot.
WARNING
REPLACE ONLY WITH SAME TYPE AND RATING
OF FUSE. (REFER TO CHART BELOW.)
Selected Voltage Line Fuse Value
120V………………….....1.0A (250V time delay)
5. Place the new FUSE into the same slot.
6. Install the FUSE DRAWER. (Refer to Figure 7.1.)