Fronius String Control 250/25 DCD DF - Manual (Page 62)

4
The device is intended solely for use as a collector and measuring device
for the solar module DC strings.The device may be operated only with the
following inverters: FRONIUS CL 36.0 / 48.0 / 60.0 and FRONIUS IG 300
/ 390 / 400 / 500.
Any other purpose does not constitute intended use. The manufacturer
shall not be liable for any damage resulting from such improper use.
Intended use also includes following all information from the operating
instructions.
Intended Use
If type 1 or type 2 overvoltage protection is desired, it can be installed in
the Fronius String Control 250/25 DCD DF to the DIN rail provided for this
purpose. The size of the over-voltage arrester may not exceed 8 TE.
- 1 Fronius String Control 250/25 DCD DF
- 2 M40 metric screw joints including counter nuts
- 50 M16 metric screw joints including counter nuts
- 20 M16 threaded plugs
- 1 M20 metric screw joint including counter nut
- 1 M20 metric threaded plug
- 1 M25 metric screw joint including counter nut
- 2 M32 metric screw joint
- 2 M40 / M32 reducers
- 1 protection against contact (attached using 2 M4 x 50 mm spacers
and 2 M4 screws)
- 1 rubber insert
- 1 plastic bolt (pre-installed)
- 1 Fire prevention leaflet
- 1 silicone tube 740 mm
- 1 silicone tube 510 mm
- 1 operating instructions
Scope of
Supply
Optional
Other System
Requirements - Fronius Datalogger
- PC with Fronius Solar.access software installed
Inverter The Fronius String Control 250/25 DCD DF is designed exclusively for
use with the following inverters:
-
FRONIUS CL 36.0 / 48.0 / 60.0
- FRONIUS IG 300 / 390 / 400 / 500