FSR CB-22 - Manual

FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43192 LIT1321B
CB-22 INSTALLATION INSTRUCTIONS
19-3/8" x 22-3/4"
DROP CEILING
PANEL MATERIAL
(SUPPLIED BY
CUSTOMER)
3. REMOVE CEILING BOX DOOR. INSTALLATION OF
19-3/8" x 22-3/4" DROP CEILING PANEL MATERIAL INTO
DOOR CAN BE DONE NOW, WHILE DOOR IS OFF, OR
DURING RE-ASSEMBLY. BEND CAPTURE TABS OVER
CEILING PANEL TO HOLD IN PLACE.
(4) CAPTURE TAB
LOOSEN SCREWS
TO OPEN CB-22 DOOR
DOOR IS
REMOVABLE.
(a) PUSH DOOR
UP TOWARDS
CEILING AND
(b) PUSH
TOWARDS
SHELF -
REVERSE
PROCEDURE
TO INSTALL
a
b
CB-22 INSTALLATION INSTRUCTIONS
SHELF
DISCONNECT
SAFETY CABLE
TO COMPLETELY
REMOVE DOOR
STRUCTURAL
CHANNEL
THREADED ROD OR CABLE TO
BE PLUMB WITH CEILING AND FLOOR
ALL MOUNTING HARDWARE
SUPPLIED BY CUSTOMER
STRUCTURAL
MEMBER
14 GA. STEEL TIE WIRE MAY BE USED
(SUPPLIED BY CUSTOMER OR USE FSR KIT)
AT 70,000 PSI TENSILE STRENGTH OR
BETTER AS REQUIRED BY BUILDING CODES.
NOTE: WIRES SUPPORT CEILING
BOX, AND ARE NOT SAFETY CABLES
ROUTE CONDUIT
(SUPPLIED BY
CUSTOMER) TO
KNOCKOUTS
AS REQUIRED
BRACKET - FSR'S
THREADED ROD
INSTALLATION KIT
(HARDWARE SUPPLIED
BY CUSTOMER)
1. INSTALL CB-22 TO A STRUCTURAL CEILING ABLE TO SUPPORT
FIVE TIMES THE NOTED GROSS WEIGHT. USE APPROPRIATE
MOUNTING METHODS BASED ON LOCAL BUILDING CODES.
INSTALL SAFETY CABLE AS REQUIRED BY LOCAL BUILDING
CODES. ROUTE CONDUITS TO BOX AS REQUIRED.
NOTE: MAXIMUM GROSS WEIGHT - 120 LBS
NOTE: THREADED ROD IS THE
RECOMMENDED CEILING BOX
MOUNTING SUSPENSION
(SHOWN), TO MINIMIZE
FIXTURE TILTING DUE
TO THE WEIGHT OF ANY
SUSPENDED EQUIPMENT.
AVAILABLE KITS (SOLD SEPARATELY):
CB-MNT1 - CABLE INSTALLATION KIT
CB-THRD - THREADED ROD INSTALLATION KIT
AC POWER INPUT
WIRING MUST BE
PERFORMED BY
A QUALIFIED
ELECTRICIAN ONLY
(4) #8-32 x 1/4"-
LONG PAN
HEAD SCREW
AC ACCESS
PLATE
2. TO INSTALL AC MAIN POWER INTO THE UNIT, REMOVE THE
AC ACCESS PLATE BY REMOVING (4) #8-32 SCREWS, AS
SHOWN. WIRING MUST BE PERFORMED BY A QUALIFIED
ELECTRICIAN ONLY. WIRING MUST BE DONE IN
ACCORDANCE WITH ALL NEC AND OTHER APPLICABLE
CODES. RE-INSTALL AC ACCESS PLATE AFTER AC WIRING IS
COMPLETE.