GAI-Tronics 12514-001 and 12514-109 PVC Coil Cord Replacement Kit - Manual

Pub. 42003-243A
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
PVC Coil Cord Replacement Kit
Models 12514-107, 12514-108, and 12514-109
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information which is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
These kits are used to replace the PVC cords for handsets with or without a press bar and are used with a
detached strain relief bushing. They are intended for use on the following models:
• 611 • 701-201 • 701-205 • 7165-002 • 701-304 • 701-902
• 6115 • 701-202 • 711-002 • 726-101 • 701-307 • 701-904
• 616 • 701-203 • 7115-002 • 7265-101 • 701-309
• 6165 • 701-204 • 716-002 • 701-302 • 701-312
These kits include the following components:
Qty Description
1 Strain Relief Bushing
1 PVC Cord, 6-foot (Model 12514-107 Kit only)
1 PVC Cord, 15-foot (Model 12514-108 Kit only)
1 PVC Cord, 25-foot (Model 12514-109 Kit only)
Installation
Models without Press Bars
Removing the Old Cord
1. Loosen and remove the screws securing the front panel. Pull the front panel assembly away from the
back enclosure. Retain for re-assembly.
2. Disconnect any connection between the front panel and the PCBA that interferes with the removal of
the front panel. Disconnect the four handset wires from the PCBA, and make note of the connection
locations.
3. If present, remove the E-clip securing the bushing and cord to the rear of the front panel.