GAI-Tronics 12514-001 and 12514-109 PVC Coil Cord Replacement Kit - Manual (Page 4)

Pub. 42003-243A
M ODELS 12514-107, 12514-108, AND 12514-109 PVC C OIL C ORD R EPLACEMENT K IT Page: 4 of 5
f:\standard ioms - current release\42003 kit manuals\42003-243a.doc
01/12
5. Remove the lower cap (transmitter cap) from the handset handle. Set aside for re-assembly. Make
note the orientation of the transmitter. Pull out the transmitter, loosen the screws holding the wires
and disconnect the black and white wires. Refer to Figure 3.
Figure 3. Handset Assembly with Press Bar
6. Remove the upper cap (receiver cap) from the handset handle. Set aside for re-assembly. Pull out the
receiver, loosen the screws holding the wires and disconnect the green and red wires.
7. Remove the press bar assembly by removing the flat-head screws securing it to the handset handle.
Remove the switch assembly from the cavity and loosen the screws for the blue and yellow wires and
disconnect.
8. Pull the wire harness out of the handset and discard the cord.