Table 80: event list settings, Figure 134: create new event list – Grandstream UCM6510 User Manual User Manual
Page 239
Firmware Version 1.0.2.5
UCM6510 IP PBX User Manual
Page 238 of 313
Figure 134: Create New Event List
Table 80: Event List Settings
URI
Configure the name of this event list (for example, office_event_list).
Please note the URI name cannot be the same as the extension name on
the UCM6510. The valid characters are letters, digits, _ and -.
Local Extensions
Select the available extensions listed on the local UCM6510 to be
monitored in the event list.
Remote Extensions
If LDAP sync is enabled between the UCM6510 and the peer UCM6510,
the remote extensions will be listed under "Available Extensions". If not,
manually enter the remote extensions under "Special Extensions" field.
Special Extensions
Manually enter the remote extensions in the peer/register trunk to be
monitored in the event list.
Valid format: 5000,5001,9000
Remote extension monitoring works on the UCM6510 via event list BLF, among Peer SIP trunks or
Register SIP trunks (register to each other). Therefore, please properly configure SIP trunks on the