Grandstream UCM6510 User Manual - Manual (Page 31)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 30 of 313
The following table shows the LCD menu options.
Table 3: LCD Menu Options
View Events
• Critical Events
• Other Events
Device Info
• Hardware: Hardware version number
• Software: Software version number
• P/N: Part number
• WAN MAC: WAN side MAC address
• LAN MAC: LAN side MAC address
• Uptime: System up time since the last reboot
Network Info
• WAN Mode: DHCP, Static IP, or PPPoE
• WAN IP: IP address
• WAN Subnet Mask
• LAN IP: IP address
• LAN Subnet Mask
Network Menu
• WAN Mode: Select WAN mode as DHCP, Static IP or PPPoE
• Static Routes Reset: Click to reset the static route setting
Factory Menu
• Reboot
• Factory Reset
• LCD Test Patterns
Press "OK" to start. Then press "Down" button to test different LCD patterns.
When done, press "OK" button to exit.
• Fan Mode
Select "Auto" or "On".
• LED Test Patterns
Select "All On" "All Off" or "Blinking" and check LED status for USB, SD,
T1/E1/J1, Phone 1/Phone 2, Line 1/Line 2 ports. After the LED test, select
"Back" in the menu and the device will show the LED actual status again.
• RTC Test Patterns
Select "2022-02-22 22:22" or "2011-01-11 11:11" to start the RTC (Real-Time
Clock) test pattern. Check the system time from LCD idle screen by pressing
"DOWN" button, or from web GUI->System Status->General page. After
the test, reboot the device manually and the device will display the correct