Figure 160: system events->alert log, Figure 161: filter for alert log – Grandstream UCM6510 User Manual User Manual
Page 284
Firmware Version 1.0.2.5
UCM6510 IP PBX User Manual
Page 283 of 313
Figure 160: System Events->Alert Log
User could also filter alert logs by selecting a certain event category, type of alert log, and/or specifying a
certain time period. The matching results will be displayed after clicking on
. Alert logs are
classified into two types by the system:
1. Generate Alert: Generated when alert events happen, for example, alert logs for disk usage
exceeding the alert threshold.
2. Restore to Normal: Generated when alert events being cleared, for example, logs for disk usage
dropping back below the alert threshold.
User could filter out alert logs of “Generate Alert” or “Restore to Normal” by specifying the type according
to need. The following figure shows an example of filtering out alert logs of type of “Restore to Normal”.
Figure 161: Filter for Alert Log