Greenheck Sleeve Extension Supplement (462103) - Manual (Page 2)

5. Products with a smoke rating (FSD models) require
that the joint between the two sleeves be sealed.
Approved caulks include:
• G.E. 1200 series silicone construction
adhesive
• Component Hardware Group (QMFZ2)
silicone SLT-5000 or SLT-5200
• Silico (QMFZ2) silicone SB or CH (E224060)
• Dow Corning (QMFZ2) silicone SLT-5200
(E40195)
• Dow R/C (QMFZ2) silicone Type RTV732.
Approved duct sealants include:
• Precision PA2084T duct sealant adhesive
• Design Polymetrrics DP1010 water base duct
sealant
• Grey Pookie
• Ductmate PROseal®
• CL Ward S seal
6. Sleeve extensions can be made to either end of
the factory sleeve. However, the total sleeve length
cannot extend more then 16 in. (406mm) on the
actuator side and not more than 6 in. (152mm) on
the non-actuator side.
7. The joint created by the factory sleeve and sleeve
extension cannot be in the plane of the partition.
462103• Sleeve Extension Rev. 5, April 2014 Copyright 2014 © Greenheck Fan Corporation
As a result of our commitment to continuous improvement, Greenheck reserves the right to change
specifications without notice.
Specific Greenheck product warranties are located on greenheck.com within the product area tabs and in
the Library under Warranties.
®
Phone: (715) 359-6171 • Fax: (715) 355-2399 • E-mail: [email protected] • Website: www.greenheck.com
Our Commitment