Highgear Aerial - Manual (Page 25)

24
english
alTImeTer
set altiMeter (continued)
12. There are two altitude memory displays showing the MaXiMuM altitude and
aCCuMulated asCent since the last time the memory was cleared. Clear each memory
using the s1 or s2 key and advance from the MaXiMuM (high) to the aCCuMulated (aCC)
memories using the s4 key.
13. Exit the altiMeter CaliBration sequence using a QuiCK press of the s5 key.
setting the altiMeter presets
The ATF8 / Alterra / Altiforce / Aerial is equipped with three altimeter preset locations. Preset
Locations are useful in the daily calibration process. If you know the exact altitude of a particular place,
you can preset your ATF8 / Alterra / Altiforce / Aerial to this location for quick calibration.
1. Start in altiMeter mode
2. press and hold the s5 key to enter the setting sequence.
3. “real” will display flashing on the screen.
4. QuiCK press the s1 key to set altitude presets. Using s1, scroll through loCation 1,
loCation 2 and loCation 3.
5. Choose the Location you would like to set. QuiCK press the s4 key to set that Location’s
altitude. The loCation’s altitude will appear flashing in the center line of the display.
6. Adjust the altitude up and doWn using the s1 and s2 keys.
7. Exit the altiMeter preset sequence using a QuiCK press of the s5 key.
8. Follow steps 1 through 7 in order to set the remaining location presets.
reCalling altiMeter presets
1. Start in altiMeter mode
2. press and hold the s5 key to enter the setting sequence.
3. “real” will display on the screen.
4. QuiCK press the s1 key to scroll through “loC 1”, “loC 2” and “loC 3.”
5. Once you have selected the desired Location, QuiCK press the s5 key to set your altimeter to
that particular location.