Highgear Aerial - Manual (Page 31)

30
english
chronoGraph
start tiMing
QuiCK press the s1 key
tiMe a lap/split
QuiCK press the s1 Key.
When the s1 key is pressed the display will flash for approximately
6 seconds showing the final lap and split time for the timed
segment as well as the number of the lap and split on the top
line of the display. At the end of the 6-second period the display will
stop flashing and show the time for the currently timing lap and split
including the 6 seconds where the previous lap and split times were
flashing on the display.
stop tiMing
QuiCK press the s2 key.
This will stop the Chronograph and show the final times for the
last lap and split which was being timed. When timing has stopped,
you then have two options.
OPTION 1 – store a run/WorKout –
press & hold the s2 key
OPTION 2 – Clear a run/WorKout prior to storing
– press & hold the s5 key
operating the Chronograph
tiMing laps and splits (50)
The ATF8 / Alterra / Altiforce / Aerial unit is capable of timing up to 50 laps and splits.
These can be stored in any combination in up to 20 individual Runs or workouts.
While the Chronograph is running, the top line will display the number of the current lap,
the middle line will show the time for the current lap and the bottom line will show the current split
time.