Highgear Aerial - Manual (Page 37)

36
english
daIly alarm
setting the daily alarM
1. Starting in alarM mode.
2. Choose the Time Zone you wish to program an alarm for in the
Time of Day screen.
3. seleCt the alarm you wish to program using the s2 key.
4. press & hold the s5 key to enter the programming
sequence.
5. adjust the hours, Minutes and ChiMe using the s1
and s2 key.
6. set and adVanCe from variable to variable using the s4
key.
7. eXit setting seQuenCe using the s5 key.
note: The ChiMe is a single beep each time a key is
pressed and a double beep at the start of each hour. The
Key press ChiMe is useful if you are trying to operate
the watch under circumstances where it is difficult to look
at the watch to confirm that an action has taken place
when a key is pressed.
note: You must choose t1 or t2 in the tiMe oF day
screen before setting the daily alarM. The Time
Zone cannot be changed during the Alarm Programming
process.
resetting the WatCh
To reset the watch back to its default values press the s1, s2,
s4 and s5 keys down at the same time. The display will light up
showing all segments followed by a sequence of screens showing
various numbers. The watch will then automatically change to the
tiMe oF day screen at 12 o’clock on the first of January.
Resetting the watch will clear any information stored in the watch.
This should be done only as a last resort.