Highgear Aerial - Manual (Page 28)

27
english
alTImeTer daTa loG memory
An altiMeter data log file tracks the following information:
1. total Feet or Meters asCended and aVerage rate oF
asCent.
2. total Feet or Meters desCended and aVerage rate oF
deCent.
3. Number of laps. A lap is counted as any change in altitude of
greater than 150’/50m UP and DOWN.
4. total tiMe for file.
start/stop log BooK
1. Start In altiMeter mode,
2. Activate the altiMeter log – press & hold s1 key. start
and log will appear on screen
3. The display will automatically revert to the altiMeter screen with
the log BooK iCon ( ) visible.
4. stop the altiMeter log – press & hold s1 key. stop and
log will appear on screen.
5. The display will automatically revert to the altiMeter screen with
the log BooK iCon no longer on the display.
Clearing the log BooK MeMory
1. To Clear an individual log, advance to the desired log using the
s4 key.
2. press & hold the s5 key. hold, Clear and the log
nuMBer will appear flashing on the display.
3. Continue to press & hold the s5 key until the message in the
lower line changes from the log nuMBer to all.
4. release the s5 key before the all indication stops flashing to
clear a single log.
5. To Clear all logs continue to press & hold the s5 key while
the all message is displayed in the lower line. When all files are
cleared, 4 dashes will be displayed in the center line.
The altiMeter data log allows you to capture specific, detailed altitude information over a
specific period of time in up to 15 individual files.