Hypertherm SuperMicro 370SBA 533Mhz - Manual (Page 55)

Chapter 5: Running Setup
5-3
Date and Time Configuration
Select the Standard option. Select the Date/Time icon. The current values
for each category are displayed. Enter new values through the keyboard.
Floppy A
Floppy B
Choose the Floppy Drive A or B icon to specify the floppy drive type. The
settings are Not Installed, 360 KB 5¼ inch , 1.2 MB 5¼ inch , 720 KB 3½
inch , 1.44 MB 3½ inch or 2.88 MB 3½ inch . Note: The Optimal and Fail-
Safe settings for Floppy Drive A are 1.44 MB 3 1/2 inch and for Floppy
Drive B are Not Installed .
Advanced Setup
Quick Boot
The Settings are Disabled or Enabled . Set to Enabled to permit AMIBIOS
to boot quickly when the computer is powered on. This option replaces the
old Above 1 MB Memory Test Advanced Setup option. The settings are:
Setting Description
Disabled AMIBIOS tests all system memory. AMIBIOS waits
up to 40 seconds for a READY signal from the IDE
hard disk drive. AMIBIOS waits for .5 seconds after
sending a RESET signal to the IDE drive to allow the
IDE drive time to get ready again. AMIBIOS checks
for a <Del> key press and runs AMIBIOS Setup if the
key has been pressed.
Enabled AMIBIOS does not test system memory above 1 MB
AMIBIOS does not wait up to 40 seconds for a READY
signal from the IDE hard disk drive. If a READY signal
is not received immediately from the IDE drive, AMIBIOS
does not configure that drive. AMIBIOS does not wait
for .5 seconds after sending a RESET signal to the IDE
drive to allow the IDE drive time to get ready again. In
Enabled, keyboard will be bypassed.
Note: You cannot run AMIBIOS Setup at system boot, because there is
no delay for the Hit <Del> to run Setup message.