Hypertherm SuperMicro 370SBA 533Mhz - Manual (Page 65)

Chapter 5: Running Setup
5-13
Hard Disk Power Down Mode
This option specifies the power conserving state that the hard disk drive
enters after the specified period of hard drive inactivity has expired. The
settings are Disabled , Standby , or Suspend . Note: The Optimal default
setting for this option is Suspend and the Fail-Safe default setting is
Disabled .
Hard Disk Timeout (Minutes)
This option specifies the length of a period of hard disk drive inactivity.
When this length of time expires, the computer enters power-conserving
state specified in the Hard Disk Power Down Mode option. The settings
are Disabled and 1 Min through 15 Min in 1 minute intervals .
Power Saving Type
The settings for this option are Sleep, Stop Clock or Deep Sleep .
Standby/Suspend Timer Unit
This allows you to set the standby timeout and suspend timeout timer unit.
The settings are 32 secs , 4 msecs , 4 min or 4 secs .
Standby Timeout
This option specifies the length of a period of system inactivity while in full
power on state. When this length of time expires, the computer enters
standby power state. The settings are Disabled and 4 Min through 508
Min in 4 minute intervals .
Suspend Timeout (Minutes)
This option specifies the length of a period of system inactivity while in
standby state. When this length of time expires, the computer enters
suspend power state. The settings are Disabled and 4 Min through 508
Min in 4 minute intervals .
Slow Clock Ratio
The value of the slow clock ratio indicates the percentage of time the
STPCLK# signal is asserted while in the thermal throttle mode. The
settings are Disabled, 0-12 . 5% , 12.5 - 25% , 25 - 37 . 5% , 37 . 5-50% , 50 - 62 . 5% ,
62 . 5-75% , or 75-87.5% .
Display Activity
This option specifies if AMIBIOS is to monitor display activity for power
conservation purposes. When this option is set to Monitor and there is no
display activity for the length of time specified in the Standby Timeout
(Minute) option, the computer enters a power savings state. The settings
are Monitor or Ignore .