Hypertherm HD3070 w/Manual Gas - Manual (Page 11)

1-8 HD3070 with Manual Gas Console Product Configuration Manual
4
SPECIFICATIONS
Figure 1-5 Cables / Hoses in Machine Cable/Hose Carrier
12
1-1/2 in.
Figure 1-4 Cables / Hoses in Rail
1 2 3 4
3/8 in.
1/4 in.
Key – Figure 1-4
4 Leads – Power Supply to RHF Console
1/4 in. Pilot Arc Lead
3/8 in. Negative Lead
1/4 in. Control Cable
5/8 in. Coolant Supply Hose
5/8 in. Coolant Return Hose
6 Leads - Power Supply to Gas Console
1/2 in. Cable – 3X2 Control
1/2 in. Cable – 3X1 Control
A Hoses – Gas Supply to Gas Console
18 Cable – Gas Console to Machine Interface
19 Cable, Control – Power Supply to
Machine Interface
20 Cable, Curr. Setpoint – Power Supply to
Machine Interface
21 Cable, Tmr-Cntr – Power Supply to
Machine Interface
12
1 2 3 4
1/2 in.
1/2 in. 1/2 in.
1/4 in.
1/4 in.
1/2 in.
5/8 in. 5/8 in.
5/8 in. 5/8 in.
5/16 in.
Quick Reference to Cable/Hose Dimensions
HD3070 System – (Ref. Fig. 2-10)
The following figures are a one-to-one representation of the HD3070 system interconnecting cables and hoses.
Figure 1-4 shows cables and hoses that would lay in the rail at the site. Figure 1-5 shows cables and hoses that
would lay in the cutting machine's cable/hose carrier. The rulers have been added to use as a guide. Arrangement
of cables and hoses laying in rails or carriers are roughly suggested here.
A 19
13 17
20
4 6
18 21
Key – Figure 1-5
13 Shielded Torch Leads –
RHF Console to Torch
17 Leads –
Gas Console to Off-Valve