Hypertherm HD3070 w/Manual Gas - Manual (Page 23)

2-12 HD3070 with Manual Gas Console Product Configuration Manual
4
ORDERING PROCEDURE
Specify the Torch Configuration
The torches for the HD3070 system are the PAC184 and PAC186. Hypertherm does not provide a torch
mounting bracket for the torches. Precision and robotic cutting machines have their own mounting
brackets that have proven to be adequate for the HD3070 PAC184 and PAC186 torches. A variety of torch
configurations are available due to the interchangeability of the torch head, quick disconnect assemblies
and torch mounting sleeves.
• Determine the type of torch, quick disconnect and mounting sleeve you need, and specify using the figure
on page 2-13 and the following brief descriptions as guides:
PAC186 Torch
This torch head comes loaded with 15-amp consumables and is more commonly used with an X-Y table.
The PAC186 is capable of cutting with up to 100 amps of current. There are two varieties: one torch
includes a retaining cap with a tab for ohmic contact initial height sensing (IHS) and the other torch comes
without the tab. Determine if the system will require ohmic contact IHS before ordering.
PAC186 Consumable Parts Kits (not shown on page 2-13)
Order one of these consumable parts kits if you specify either of the PAC186 torches. One kit contains an
extra torch body, and the other does not. Both kits include consumables for cutting with 15, 30, 50, 70 and
100 amps.
Quick Disconnect Assembly – Straight
Can be used with either torch. More commonly used with the PAC186.
10 Inch Mounting Sleeve
Can be used with either torch depending on cutting machine's torch mounting design.
PAC184 Torch
This torch head comes loaded with 30-amp consumables and is more commonly used in robotic
applications. The PAC184 is capable of cutting with 15 and 30 amps of current.
PAC184 Consumable Parts Kits (not shown on page 2-13)
Order one of these consumable parts kits if you specify the PAC184 torch. One kit contains an extra torch
body, and the other does not. Both kits include consumables for cutting with 15 and 30 amps.
Quick Disconnect Assembly – 45°
Can be used with either torch. More commonly used with the PAC184.
8 Inch Mounting Sleeve
Can be used with either torch depending on cutting machine's torch mounting design.
10 Inch Strain Relief and Hose Clamp
Use with Quick Disconnect Assembly – 45°
b 11
a 11
11
a 10
10
9
8
7a
7