Hypertherm HD3070 w/Manual Gas - Manual (Page 27)

2-16 HD3070 with Manual Gas Console Product Configuration Manual
4
ORDERING PROCEDURE
Specify the Control Cable Between the Power Supply and the Cutting Machine
Interface
• Based on the distance (the path the cable will take) between the power supply and the machine computer
interface, order the appropriate cable.
Specify the Current Setpoint Cable Between the Power Supply and the Cutting
Machine Interface or Between Power Supply and Remote Current Control (RCC)
A cable is needed between the power supply and machine interface (if current is set with the cutting
machine computer) or between the power supply and the remote current control unit (if current is set with
the RCC).
• Determine if the cutting machine's computer will be setting current or if there will be a remote current
control unit installed to set current. Based on the distance between the power supply and the cutting
machine interface or the RCC, specify the appropriate length cable.
Specify the Timer-Counter Cable Between the Power Supply and the Cutting
Machine Interface or Between Power Supply and Timer-Counter
A cable is needed between the power supply and machine interface (if monitoring of starts and errors will
be done with the cutting machine computer) or between the power supply and the timer-counter unit (if
monitoring will be done with the timer-counter).
• Determine if the cutting machine's computer or the timer-counter will be used. Based on the distance
between the power supply and the cutting machine interface or the timer-counter, specify the appropriate
length cable.
20
19
18