Hypertherm HD3070 w/Manual Gas - Manual (Page 17)

2-6 HD3070 with Manual Gas Console Product Configuration Manual
4
ORDERING PROCEDURE
Single-System Ordering Procedure
System Ordering for HD3070 with Manual Gas Console – Robotic Applications
Special numbers have been established for ordering an entire HD3070 system. Under these numbers, all cables,
hoses and leads are at fixed lengths. Refer to the list below and Figure 2-3 on the following page for clarification of
the system.
1 HD3070 Power Supply, Manual
2 HD3070 Manual Gas Console
3 Remote High Frequency (RHF) Console
4 15 Ft Leads Between Power Supply and RHF Console
5 39.4 Ft Work Cable Between Power Supply and Work Table
6 10 Ft Leads Between Power Supply and Manual Gas Console
7 PAC184 Machine Torch Assy
8 PAC184 Machine Torch Quick Disconnect Assembly and Leads:
8a PAC184 45° Quick Disconnect
8b 8 Inch Torch Mounting Sleeve
8c 10 Inch Strain Relief
8d 4 Ft Hoses from Off-Valve Assy to Torch
8e Off-Valve Assy (Off-Valve comes with or without Blow Down Solenoid Valve)
8f
35 Ft Leads from Gas Console to Off-Valve Assy
8g 19.7 Ft Leads from RHF Console to Torch (Leads come with or without Blow Down Check Valve & Hose)
9 28.2 Ft Control Cable Between Power Supply and Cutting Machine Interface
10 28.2 Ft Current Setpoint Cable Between Power Supply and Cutting Machine Interface
11 28.2 Ft Timer-Counter Cable Between Power Supply and Cutting Machine Interface
If this exact configuration will work for your particular site, simply order by using the appropriate system number
listed directly below.
078062 HD3070 Plasma System w/Manual Gas Console, 200V, 50/60 Hz, 3Ø
078063 HD3070 Plasma System w/Manual Gas Console, 208V, 60 Hz, 3Ø
078064 HD3070 Plasma System w/Manual Gas Console, 220/380/415V, 50/60 Hz, 3Ø
078065 HD3070 Plasma System w/Manual Gas Console, 240/480V, 60 Hz, 3Ø
078066 HD3070 Plasma System w/Manual Gas Console, 600V, 60 Hz, 3Ø
To customize a system, begin on page 2-8 and use the order form.