Hypertherm HT4100 Plasma Arc Cutting System Operating - Manual (Page 19)

2-2
INTRODUCTION & SPECIFICATIONS
HT4100 Instruction Manual: Operation
INTRODUCTION
The instructions to install, operate and maintain the HT4100 system have been separated
into three manuals. The following is a list of the manual titles, part numbers, and contents:
HT4100 Instruction Manual: Installation (#801650)
This manual gives pertinent information for the pre-installation supply requirements,
installation, and post-installation requirements for the HT4100 system.
Also included in this manual are specifications of the components of the HT4100 system,
system interconnect diagrams, and accompanying drawings.
HT4100 Instruction Manual: Operation (#801660)
This manual describes the controls and indicators for the system units, explains how to
start-up and operate the HT4100 system, contains cut chart tables, gives instructions to
remove and replace consumable parts, and provides routine inspection and cleaning
information.
HT4100 Instruction Manual: Maintenance (#801670)
This manual contains basic troubleshooting tips, and a parts list.
It is our hope that this manual set will aid and answer most questions on installing,
operating, and ordering parts for your HT4100 system.
If any questions do arise, please call our Customer Service at 1-800-643-0030 or Field
Service group at 1-800-643-9878.
.