Hypertherm HT4100 Plasma Arc Cutting System Operating - Manual (Page 32)

3-6
OPERATION
HT4100 Instruction Manual: Operation
FRONT PANEL CONTROLS and INDICATORS (Cont.)
Digital Remote (DR) V/C Module (Fig. 3-4)
• VOLTAGE Adjust Pot
Adjusts the cutting arc voltage from 100 to 200 volts. Values are chosen from the Cut
Charts and depend on the type of metal to cut, and metal thickness.
• VOLTAGE LEDs
Displays cutting voltage.
• CURRENT Adjust Pot
Adjusts the cutting arc current from 100 amps to 400 amps. Values are chosen from the
Cut Charts and depend on the type of metal to cut, and metal thickness.
• CURRENT LEDs
Displays cutting current during cut sequence.
• UP/DOWN LEDs
Indicates that torch height is being adjusted up or down.
Programmable Remote (PR) V/C Module (Fig. 3-5)
• VOLTAGE LEDs
Displays cutting voltage during cut sequence.
• CURRENT LEDs
Displays cutting current during cut sequence.
• UP/DOWN LEDs
Indicates that torch height is being adjusted up or down.