Datalogic Scanning PDA - Manual (Page 13)

User’s Manual 1
Chapter 1
Getting Started
Quick Start
Following is a brief summary of the steps needed to set up FMU for configur-
ing terminals. See the references to each section for further information.
1. Read “System Requirements” on page 4 and “Before You Begin” on
page 5 .
2. Set Up Terminals
• Establish communication from terminal to host — see the PRG
for your terminal type.
• Enable FMU on terminal — see “Terminal to FMU Server
Communications” on page 49 .
3. Install FMU
See “Installing FMU” on page 5 .
4. Set Up FMU
See “Firewalls and File Sharing” on page 6 and “Setting Up FMU” on
page 8 .
5. Define Configuration Settings
See Chapter 4 , “Configuration Settings” on page 41 .
6. Add Terminals to FMU
See “Adding Terminals” on page 37 .
7. Update Terminals
See “Updating Terminals” on page 51 and “Updating RF Terminals”
on page 55 .
CAUTION
FMU will override any previously-defined settings on a terminal.