Datalogic Scanning PDA - Manual (Page 68)

Terminal to FMU Server Communications
56 Falcon ® Management Utility (FMU)
Figure 26. Terminal Updater prompt
If the operator taps Yes , the terminal will be immediately updated.
Scheduled Update Time
A second option is available only on the terminal itself. This option is config-
urable from the
Falcon Config application on the terminal. See “Enabling Ter-
minals for RF Connectivity” on page 52 .
If an update was scheduled on the terminal, the FMU client on the terminal
will automatically trigger an update within the specified hour. The terminal
needs to be on in order for the update to proceed. It is advised that the unit be
left in its Datalogic Dock if unattended.
Terminal Configuration Settings
For diagnostic purposes, you can display an individual terminal’s configuration
settings. This view is similar to the group configuration view; however, the
data within this view reflects settings on the selected terminal.
To access terminal configuration settings:
1. Expand the view of the terminal you want to configure by clicking on
the plus sign (+) to the left of the terminal.
Since terminal settings are superseded by group settings, the next time the terminal is
updated the defined group settings will be applied, overwriting changes made with
Terminal Configuration.
On units with Direct Connection, wait until the FMU Update
or Mgmt. Utility Client dialog on the terminal indicates ‘Idle’
mode before selecting this option.