Maintenance and cleaning, 1 monitoring and maintenance, Cleaning – Ivoclar Vivadent Stratos 200 User Manual
Page 18
39
This chapter describes the user maintenance and cleaning procedures for the Stratos 200. Only those tasks that can be carried out by
qualified dental lab experts are listed. All other tasks must be performed by qualified service personnel at a certified Ivoclar Vivadent
Service Center.
7. Maintenance and Cleaning
7.1 Monitoring and maintenance
The time for these maintenance procedures depends on the frequency of use and the working habits of the user. For these
reasons, the recommended times are only approximates.
7.2. Cleaning
Protect the Stratos 200 from acids and solvents
(e.g. MMA) to prevent the finish from being damaged.
What
Check centric rubber band for damage and
cracks.
Check if knurled screws are dirty.
Check if joint bolt is sufficiently
lubricated.
Check if incline support holder and holding
device are dirty.
Part
Centric rubber band
Knurled screw
Joint bolt
Holding device for incline support
holder
Frequency
Every six months
Weekly
Monthly or as necessary
Weekly or as necessary
What
Knurled screws contaminated with wax or
plaster
Joint bolt contaminated with dust
Frequency
Weekly or as necessary
Weekly or as necessary
Cleaning agent/Measure
Rinse with warm water
Rinse with warm water