Ivoclar Vivadent IPS e.max Abutment Solutions Cem Kit v.3 - Manual (Page 14)

14
Additional notes
– Multilink Implant should be processed at room tem-
perature. Cool temperatures may render the material
difficult to dispense and mix and prolong working
and curing times.
– Apply Liquid Strip cautiously to avoid blending it
with or displacing the composite.
Leave Liquid Strip on the cement joint until poly-
merization is complete.
– Polyvinyl siloxanes such as Virtual Extra Light Body
Fast Set are chemically resistant. Unpolymerized
material may stain clothing.
Warning
– Prevent any contact of uncured Multilink Implant
and Monobond Plus with skin / mucous membrane
and eyes. When unpolymerized, these products may
cause slight irritation and lead to a sensitization
against methacrylates. Commercial medical gloves
do not provide protection against the sensitizing
effect of methacrylates.
– Monobond Plus:
– Highly flammable
– Irritating
– Product contains ethanol!
– Keep away from sources of ignition.
– Virtual Extra Light Body Fast Set:
If uncured material comes into contact with the
eyes, rinse immediately with plenty of water. If
irritation persists, consult a physician. If the material
comes into contact with the skin, rinse with water
and soap.
Shelf life and storage
– Do not use the individual components of the
IPS e.max Abutment Solutions Cem Kit after the
indicated date of expiration.
– Storage temperature of Monobond Plus, Liquid Strip
and Virtual Extra Light Body Fast Set:
2–28 °C/36–82 °F
– Storage temperature of Multilink Implant:
2–8 °C/36–46 °F
– Shelf life: see imprint on syringe/bottle/cartridge
– Monobond Plus and Liquid Strip:
Close bottle/syringe immediately after use.
– Multilink Implant and Virtual Extra Light Body Fast
Set:
Leave mixing tip on the syringe/cartridge after use.
The material will polymerize within the mixing tip,
functioning as a natural cap.
Keep out of the reach of children!
For use in dentistry only.
Date information prepared: 01/2012, Rev. 1
Manufacturer:
Ivoclar Vivadent AG, FL-9494 Schaan / Liechtenstein
The material has been developed solely for use in dentistry. Processing should be carried
out strictly according to the Instructions for Use. Liability cannot be accepted for damages
resulting from failure to observe the Instructions or the stipulated area of application. The
user is responsible for testing the products for their suitability and use for any purpose not
explicitly stated in the Instructions. Descriptions and data constitute no warranty of
attributes and are not binding.