Ivoclar Vivadent IPS e.max Press Abutment Solutions v.2 - Manual (Page 11)

11
Isolate the Ti base and the pin with a thin application of separator.
Design the resin coping on the entire Ti base.
Loosen and remove the pin by rotating the resin coping.
Place the resin coping back on the Ti base and check the fit and dimension (e.g. silicone key). If necessary, adjust the coping by means of rotary instruments.
Design the coping in such a way that it can subsequently be covered with modelling wax.
Apply the modelling resin to the Ti base in increments.
Remove the resin coping together with the pin from the Ti base.
Eliminate possible over-contoured areas of the resin coping at the transition area to
the Ti base by means of rubber polishers.
Application
procedure
­–
­Fabrication
­Hybrid
­Abutment
­and
­Hybrid
­Abutment
­Cr
own