Kemppi KempArc DT400 - Manual (Page 7)

EN
• Make sure the airflow to and from the machine is unrestricted.
• This electromagnetic compatibility (EMC) of professional equipment is usually designed
for industrial use. Such class-A equipment is not intended for use in residential locations
where the electrical power is provided by the public low-voltage supply system. The
machine may interfere with sensitive home electronic devices.
gas bottles and pneumatic devices
• Adhere to the instructions for handling pneumatic devices and gas bottles.
• Make sure that gas bottles are used and stored in properly ventilated spaces. A leaking gas
bottle may replace the oxygen in the inhaled air, causing suffocation.
• Before use, make sure that the gas bottle contains gas suitable for the intended purpose.
• Always fix the gas cylinder securely in an upright position, against a cylinder wall rack or
purpose-made cylinder cart.
• Never move a protective gas bottle when the flow adjuster is in place. Put the valve cover
in place during transportation.
• Close the cylinder valve after use.
1.3 intrODuCtiOn
KempArc™ SYN is a product family for welding automation that includes all welding devices
needed in robot welding. The KempArc™ SYN welding system includes the following devices:
• KempArc™ sYn 300, sYn 400 and sYn 500 are synergetic welding power sources
designed particularly for welding automation that are suitable for MIG welding with direct
current. There are three power types of power sources: the 300, 400 and 500 ampere
models. For more information on using power sources and their functions, see "Power
source".
• rF 59 is a control panel that contains the programs and welding parameters needed
in controlling the welding hardware. The panel functions allow the user to control the
operation of the welding hardware and adjust its welding settings. The control panel is
located in the front panel of the welding power source. For more information on using the
control panel and its functions, see "Control panel".
• KempArc™ Dt 400 is a wire feeding device that feeds welding wire to the welding robot
at the speed it requires at any time. For more information on using the wire feeder and its
functions, see "Wire feeder".
This guide presents the functions, operation and technical properties of the above devices.
The devices also include the KempArc™ Cool 10 cooler, but its functions and features are
presented in a separate guide.
The KempArc™ Synergic hardware is connected to the welding robot control system with the
control unit on top of the power source.

KempA
rc
SY
N
300,
400,
500
/
©
Kemppi
O
y
/ 0808
FI
SV
NO
DA
EN
DE
NL
FR
ES
PL
RU