Kemppi ProMXE - Manual (Page 12)

12 – KEMPPI PRO EVOLUTION, MXE / 0547 © KEMPPI OY
1
2
3
4
5
6
7
8
12
13
14
16
15
11
10
9
3. MXE FUNCTIONS
3.1. WELDING PROCESS SELECTION
1. MMA selection, power source is switched on open circuit voltage.
2. MIG welding with 2 sequence start switch function, MIG 2T.
3. MIG welding with 4 sequence start switch function, MIG 4T.
4. Selecting key for MIG 2T / MIG 4T.
3.2. MIG PROCESS SELECTION
5. Synergic PulsedMIG welding: Welding process where by pulsing the
welding current is produced a controlled, spatterfree filler material trans-
fer into weld piece. Pulse parameters of power source are automatically
changed according to wire feed speed (synergy). This enables welding
power level control by using only one control knob. Dependence of pulse
parameters on wire feed speed is defined by selecting synergic curve for
filler wire and gas you are using.
6. Synergic MIG/MAG welding (1-MIG): MIG welding, where other parameter values are
automatically changed according to wire feed speed. This enables welding power level
control by using only one control knob. Dependence of welding parameters on wire feed
speed is defined by selecting synergic curve for filler wire and gas you are using.
7. MIG/MAG welding with independent wire feed speed and voltage controls.
8. MIG process selection key; MIG/MAG, 1-MIG, PulsedMIG
3.3. 1-MIG / PULSEDMIG SYNERGIC CURVES SELECTION
9. MIG process selection key.
10. Indicator LED of synergic MIG/MAG welding.
11. Indicator LED of synergic PulsedMIG welding.
12. Selection keys of material groups:
Fe: iron-based filler wires, also flux cored filler wires.
Al: aluminium-based filler wires, for example AlMg, AlSi.
Ss: stainless filler wires, for example AlSi 316L.
X: special wires, for example CuAl8, NiCu30, CuSi3.
13. Display for selected filler wire material.
14. Selection and display for shielding gas you are using.
15. Selection key and display for wire diameter.
16. Program numerical display.
Note! Synergic functions are marked with red colour.