Kemppi ProMXE - Manual (Page 18)

18 – KEMPPI PRO EVOLUTION, MXE / 0547 © KEMPPI OY
5
6
7
8
47
48
49
50
51
52
53
55
54
5
6
7
a) Select the MIG process, MIG/MAG (7), 1-MIG (6) or PulsedMIG
(5), the parameters of which you want to change.
b) Go to SETUP change state by simultaneous pressing 50 (keys 33 and
49).
c) Select the parameter to be adjusted with key 51. Parameter names are
to be seen in display 52 and parameter value in display 53.
d) Adjust parameter value upwards (+) or downwards (-) with keys 54.
e) Store the adjusted value into memory with key 55.
3.11.2. Changing of parameters in SETUP change mode
f) Factory value of selected parameter can be checked by
going over briefly to FACTORY mode 47, in which case
factory value of parameter in question is displayed in 53.
g) Factory values of all parameters for selected MIG process
can be copied as USER parameter values by selecting
as parameter RESTORE FAC ALL and by pressing on
memory storing key 55.
h) Go back to weld mode by another simultaneous pressing 50
(keys 33 and 49).
3.11.3 Storing SETUP parameters into MXE memory channels
a) Select the settings and control values with the MIG process you are using, MIG/MAG (7),
1-MIG (6) or PulsedMIG (5).
b) Select SET mode of memory function by pressing key 37.
c) Choose the memory channel by pressing CH- (38) or CH+ (39).
d) Store the settings by pressing the SAVE key (41). If the memory channel is empty (the LED
is blinking), the SETUP parameters cannot be stored in memory function.
e) Go over to SETUP change state by simultaneous pressing (50) of keys 33 and 49.
f) Select the parameter to be controlled with key 51.
g) Adjust the parameter value up (+) or down (-) by pressing key 54.
h) Store the adjusted parameter into memory with key 55.
i) Return to memory function by another pressing (50).
j) Start welding, adjust the values if needed and store with SAVE key.
k) Leave SET function mode by pressing 37.