Operating heater, Installation – Desa CGS2718NA User Manual

Page 18

Advertising
background image

www.desatech.com

113101-01C

18

4. Place crossover log (#5) onto the pin (left) on

middle log (#1) and onto the pin on front left

log (#3) (see Figure 24).

5. Place crossover log #6 onto the pin (right)

on middle log (#1) and onto the pin on back

log (#2) (see Figure 24).

6. Place crossover log (#7) onto pin on crossover

log #6 and pin on right front log (#4) (see

Figure 25).

5. Add lava rock around base of heater if de-

sired. Do not place any lava rock on logs or

burner.

INSTALLATION

Continued

Grate Fingers

Figure 23 - Installing Front Logs

(#3 and #4)

Figure 24 - Installing Crossover Logs

(#5 and #6)

Crossover
Log (#5)

OPERATING HEATER

MANUALLY-CONTROLLED

MODELS

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier

from a neighborʼs phone. Follow the

gas supplierʼs instructions.

• If you cannot reach your gas supplier,

call the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the

knob will not push in or turn by hand, donʼt

try to repair it, call a qualified service tech-

nician or gas supplier. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has been

under water. Immediately call a qualified

service technician to inspect the appliance and

to replace any part of the control system and

any gas control which has been under water.

Log #4

Log #3

Crossover
Log (#6)

Figure 25 - Installing Crossover Log (#7)

Crossover
Log (#7)

Advertising