Kreg KRS1035 Multi-Purpose Shop Stand User Manual
Page 4
2
Thread a nut (7) onto each leveler (8) until it is approximately ¼”
from the leveler pad. Insert the levelers into the feet. Thread a
second nut onto each leveler and fi nger-tighten it.
Assembly
Mobilize your stand
Add mobility to your bench with Kreg Heavy-Duty Casters (Item
#PRS3090). These casters feature a dual-locking mechanism
that keeps the caster from rolling and pivoting, resulting in an
extremely stable work station.
1
Place your bench top (not included) face-down on your work
surface. Center the upside-down stand on it. Using a 6”-long #2
square-drive bit, drive the
3
⁄
4
" wood screws (9) through the holes in the
top fl anges and into the bench top. Turn the bench upright.
Join the Stand to Your Bench Top
2
OPTION: The Kreg Precision Router Table Top PRS1025 has
pilot holes that match the hole locations in the stand rails. When
mounting this table top, align the rail holes with the pilot holes and drive
the screws.
1
To adjust the levelers, back off the top fl ange nut, hold the hex
shank on the leveler stud with one wrench and turn the bottom
fl ange nut up or down as needed with a second wrench. With all levelers
adjusted, tighten the top fl ange nuts.
Level the Bench
8
7
!
ATTENTION
Make sure the thickness of your bench top
accommodates the ¾”-long screws.