Legrand SPDU8-1U User Manual - Manual (Page 11)

8
5.1 Starting Configuration Menu:
There are four ways to start the Configuration Menu:
1) Local Master Port access method. Run a terminal program
from a work station via serial connections between a serial
port from your work station and the Local Master Port of
the system.
2) External Modem device access method. Run a terminal
program from a remote work state and establish the
connection via a telephone line.
3) Telnet access method. Your workstation and the system are
connected to LAN.
4) Web access method. Your workstation and the system are
connected to LAN.
If you have already logged on to the system, enter the
command “setup” and you will see “Main Menu” table as shown
in Figure 15. Without login to the system, if you enter command
“setup” you will see the following screen:
Menu selection 1: When you enter the system as an
anonymous user, you can start operate serial console ports or
power outlets as far as they are not reserved by other users.
However, you can only view system configuration parameters
and are not able to make system configuration changes.
Menu selection 2: If you already have accounts established
and want to start configuring the system or to change serial
console port and power outlet operation status, choose this
menu option.
Menu selection 3: If you do not have an account on the system
or if you have an account already and want to modify your
account or delete an account, select option 3.
Menu selection 4: Lists help information.
Menu selection 5: Exit menu operation.
5.2 System Main Menu:
This is a top level system main configuration menu, as shown in
Figure 15 and 16.
5 USING CONFIGURATION MENU
************************************************************
* *
* *
* Login Menu *
* *
* *
***************** *******************************************
>
> 1) Anonymous (Visitor) login
2) Login
3) Help
4) Quit
>Enter
your selection:
Figure 14 – Menu Configuration – Login Menu
************************************************************
* *
* *
* Main Menu *
* *
* *
************************************************************
>
> 1) Reboot Power Outlet
2) Setup System
3) Setup TCP/IP Network
4) Configure Serial Console Port
5) Configure Power Outlet
6) Setup New or Existing Accounts
7) Reload Factory Defaults
8) Save Settings
9) Quit
>Please enter your selection :
Figure 15 - System Main Menu (Terminal Program Screen)