LSC Lighting MINIM - Manual (Page 21)

MINIM Operator Manual V1.0 Chases
LSC Lighting Systems (Aust) Pty. Ltd.
Page 17 of 27
Release [F/A] and then the Playbacks will flash twice again and reveal the stored memories. At
this point you can choose another memory to preview, or if finished previewing,
press
[memory]
to return to run mode
Note: Preview is always “blind” – the current stage output is not affected.
6.5 EDIT A CHASE
To enter the MEMORY EDIT mode, press and hold [MEMORY] until the EDIT LED is lit.
Similarly, to exit the MEMORY EDIT mode, press and hold
[MEMORY]
until the RUN LED is lit.
You may edit a Chase live or blind (faded down). If the Chase is faded up on stage you will see the
changes. When you edit the Chase, its channel levels for each step are shown on the F/A LED
indicators. The LEDs will fade in the crossfade time (if any). Their final intensity reflects the levels of
those channels in each step of the Chase.
To edit a Chase, press and hold [MEMORY] button until EDIT LED is lit. All Playbacks will flash
twice to indicate possible memory location choices, then Playbacks already containing Chases in
that page will flash quickly. Playbacks containing Scenes will light and empty Playbacks are not lit.
Press [F/A] (Chase number to edit). The channel levels of the first step will be displayed on the
F/A LEDs and the FUNCTION and START/STOP/STEP buttons LED will flash.
To view the number of steps in the Chase, press and hold the [start/stop/step] button. The bank
fader F/A LEDs will light to indicate the number of steps (up to 24) and the current step will flash
quickly. To change the current step to another, press and hold
[start/stop/step]
then tap the
required [F/A] button (step number). The Chase will now advance to the selected step and the
channel levels of that step will be displayed on the F/A LEDs. You can also step through the chase
in programmed order by repeatedly pressing the [start/stop/step] button.
TO EDIT THE CHANNEL LEVELS OF A STEP IN A CHASE
Select the step to be edited (above) The channel levels in the step will be displayed on the F/A
LEDs. To adjust a channel level, press and hold the [F/A] (channel number). The level of that
channel will be displayed on the Edit Value Scale on the Red Bank F/A LEDs. The display shows
the level of channel output in 5% increments using the 10 LEDs – A LED at full intensity indicates
10% and a LED at ½ intensity indicates 5%.
Whilst holding the
[F/A]
(channel number) you can adjust the level by fading the
[FLASH/LEVEL]
fader. The fader does not become active until the level of the fader matches
the recorded level, thus preventing a sudden jump in level. The Edit Value Scale will follow the level
set by this fader. To remove a channel set its level to zero. Release the
[F/A]
(channel number).
The new level will be recorded. If desired, select a new channel to adjust, including channels not
previously recorded in the step.
TO EDIT THE EFFECTS IN A CHASE
To change the recorded effect on a Chase, edit the Chase (above) then press and hold
[function].
All EFFECTS LEDs will flash twice to indicate possible choices and then the current
programmed effects will flash quickly.
TO CHANGE DIRECTION OF A CHASE
To change the direction, hold down the [function] button, then press [<] (reverse) or [>]
(forward), then release [function] .
TO CHANGE PATTERN OF A CHASE
To change the Chase pattern, hold down [function] tap [random], [bounce] or [single],
then release
[function]
.