Marantz SR5008 - Manual (Page 109)

109
Appendix Tips Settings Connections Contents
Front panel Display Rear panel Index Remote
Playback
Direct playback
Sound recorded in source is played as is.
1 Press PURE to select “DIRECT”.
Direct playback begins.
%
• This can also be set by pressing PURE DIRECT on the main unit.
Pure Direct playback
This mode is for playback with higher sound quality than in “DIRECT”
mode, by turning off the front panel display panel, which can eliminate
faint low level noise from creeping into sensitive analog circuitry.
1 Press PURE to select “PURE DIRECT”.
The display goes dark, and Pure Direct playback begins.
The PURE DIRECT indicator lights.
%
• In DIRECT and PURE DIRECT sound modes, the following items cannot be
adjusted.
• Tone (vpage 143)
• M-DAX (vpage 143)
• MultEQ® XT (vpage 145)
• Dynamic EQ (vpage 145)
• Dynamic Volume (vpage 146)
• This can also be set by pressing PURE DIRECT on the main unit.
NOTE
• Video signals are only output when HDMI signals are played in the PURE DIRECT
mode.
• When the PURE DIRECT mode has been selected, the display turns off after about
5 seconds.