Marantz SR7300N - Manual (Page 13)

10
ENGLISH
, AC OUTLET
Connect the AC power cables of components such as a DVD and CD
player to this outlet. UNSWITCHED outlet is provided.
This is always live as long as the SR7300 is plugged into a live outlet.
A component connected here may be left on permanently, or may be
switched off with its own power switch.
Caution:
• In order to avoid potential turn-off thumps, anything plugged in
here should be powered up before the SR7300 is turned on.
• The capacity of this AC outlet is 100W. Do not connect devices
that consume electricity more than the capacity to this AC
outlet. If total power consumption of connected devices
exceeds the capacity, protection circuit shuts down the power
supply.
. Speaker outputs terminals (for Main
room)
Six terminals are provided for the front left, front right, front center,
surround left, surround right and surround back speakers.
⁄0 Subwoofer Output
Connect this jack to the line level input of a powered subwoofer. If an
external subwoofer amplifier is used, connect this jack to the
subwoofer amplifier input. If you are using two subwoofers, either
powered or with a 2 channel subwoofer amplifier, connect a “Y”
connector to the subwoofer output jack and run one cable from it to
each subwoofer amplifier.
⁄1 7.1 CHANNEL or AUX2 INPUT
By connecting a DVD Audio player, SACD multi channel player, or
other component that has a multi channel port, you can playback the
audio with 5.1 channel or 7.1 channel output.
⁄2 Multiroom Outputs (Audio L&R, Video)
These are the audio and video output jacks for the Multi zone (Multi
room).
Connect these jacks to the optional audio power amplifiers or video
display devices to listen and view to the source selected by the
multiroom system in a remote room.
⁄3 DC TRIGGER output terminals
Connect a device that needs to be triggered by DC under certain
conditions (screen, power strip, etc…)
Use the system OSD setup menu to determine the conditions by which
these jacks will be active.
Note:
• This output voltage is for (status) control only, It is not
sufficient for drive capability.
⁄4 MULTI ROOM REMOTE IN/OUT
terminals
IN: Connect to multi-room remote control device, available from
your Marantz dealer.
OUT: Connect to the Marantz component equipped with remote
control (RC-5) terminals in Multi zone (Multi room).
⁄5 REMOTE CONT. IN/OUT terminals
Connect to a Marantz component equipped with remote control (RC-
5) terminals.
⁄6 AUDIO IN/OUT (CD, TAPE, CD-R, TV,
DVD, VCR1, DSS/VCR2)
These are the analog audio inputs and outputs. There are 7 audio
inputs (4 of which are linked to video inputs) and 4 audio outputs (2 of
which are linked to video outputs). The audio jacks are nominally
labeled for cassette tape decks, compact disc players, DVD players
and etc.... The audio inputs and outputs require RCA-type connectors.
⁄7 DIGITAL INPUT (Dig.1 - 6) / OUTPUT
(coaxial, optical)
These are the digital audio inputs and outputs. There are 3 digital
inputs with coaxial jacks, 3 with optical jacks.
The inputs accept digital audio signals from a compact disc, LD, DVD,
or other digital source component.
For digital output, there is 1 coaxial output and 1 optical output.
The digital outputs can be connected to MD recorders, CD recorders,
DAT decks, or other similar components.