Marantz UD7007 - Manual (Page 38)

35
HDMI control functions
The HDMI connection not only transmits video and audio but also
convey information between the connected devices. The HDMI
control function conveys control signals between the devices to
enable them to link with each other. This is a useful function. For
example, when you perform a power-related operation on one device,
then the corresponding power operation is also performed on other
devices connected with that device.
n Operations possible by HDMI control
• Turning off the TV’s power turns the unit’s power to standby.
• Operating the unit via the TV’s remote control.
(When the TV’s remote control has player operation buttons)
n Setting procedure
1 From “HDMI AMP On” or “HDMI MONITOR
On”, select the HDMI output connector for which
you want to enable the HDMI control function.
SETUP menu “System” – “HDMI Control” ( vpage 39 ).
• You cannot enable the HDMI control function for both HDMI
outputs simultaneously. It is selectable.
2 Turn on all devices that are connected to the HDMI
output connector set in step 1.
3 Set the HDMI control function for all devices
connected by HDMI cable.
• Please consult the operating instructions for the connected devices
to check the settings.
• Carry out steps 2 and 3 should any of the devices be unplugged.
4 To ensure that the unit’s HDMI video output is
projected on the TV screen, change the input function
of the TV and AV receiver.
5 When you turn the TV’s power to standby, check
that the power of the unit and AV receiver also goes
on standby.
If the HDMI control function does not operate properly, check the
following points.
• Is the TV or AV receiver compatible with the HDMI control function?
• Are the HDMI control function settings of all equipment correct?
(Step 3)
• After setting, did you add another HDMI device connection or make
any changes in the connections? If so make the settings again.
• Is HDMI control enabled output correct assignment?
• Is the unit in Energy Saving Standby?
NOTE
• Some functions may not operate depending on the connected TV
or AV receiver. Check the owner’s manual of each device for details
beforehand.
• When “HDMI Power Off Control” ( vpage 39 ) is set to “Off”,
the unit does not go to standby even if the connected device is in
the standby mode.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
DVD