Dish Network 512 - Manual (Page 26)

Page 21
Remote Controls
TV Antenna/Cable In
The TV A NTENNA /C ABLE I N
is used if you want the satellite
receiver to connect the tuner of the nearby TV to an over-the-air
antenna or cable-TV distribution system when the satellite
receiver is turned off or when using the TV/VIDEO button on
the remote control. Use a coaxial cable to make this connection
to an over-the-air (OTA) antenna or cable-TV system. The TV
A NTENNA /C ABLE I N
connection is color-coded black. Your TV
must be connected to the C HANNEL 3-4 output to use this feature.
TV2 Connections
Do not use any TV2 connections to connect to your TV. These connections are
inactive.
Other Connections
Satellite In
The S ATELLITE I N
connections are used to
receive satellite TV signals from the dish
antenna. The connection is made using
RG-6 coaxial cable. The S ATELLITE I N
connections are color-coded blue.
Note : Both S ATELLITE I N
connections must be used for proper operation of this
dual-tuner receiver. You may use a DISH Pro Plus input-signal separator.
Remote Antenna (for optional accessory)
The R EMOTE A NTENNA
port receives UHF Pro signals
from an optional IR/UHF Pro remote control so that it can
control menus and programming from another room.
Connect this antenna here, and place it so that it does not
touch anything. If you do not connect the antenna, you
cannot use a UHF-enabled remote to control the receiver’s
menus and programming. The
R EMOTE A NTENNA
port is color-coded green.
Telephone Jack
The T ELEPHONE J ACK
is used to connect the receiver to an
active telephone line. Use a standard RJ-11 telephone cable
assembly to make the connection. You must keep the receiver
connected to an active telephone line. Otherwise, you may not
be able to order pay-per-view programs, use all of the DISH
Interactive features, or access other customer services from DISH Network.
Remote Controls
Remote controls give you easy access to all the features of your satellite
receiver. You can set up a DISH Network four-component remote to control the
Tip: If you connect
a cable to the TV/
Antenna In port,
attach the black
cable sticker to the
cable near where it
attaches to the
receiver. The
stickers are
located inside the
front cover of this
guide.