Dish Network 512 - Manual (Page 99)

Chapter 3
Page 94
Using the System
amp.
Other Remote Control Features
Switch Between TV and AUX Device Volume Control
When you set up the remote to control a TV, the mute and volume buttons are
automatically set to control the TV volume. However, if you want to use the
AUX mode to control an audio amplifier or other device with a volume setting,
you can set up the remote to control that device’s volume instead of TV volume.
To set the remote to control the AUX device’s volume :
1. Press and hold the AUX mode button for three seconds, and then
release it. The AUX mode button will blink.
2. Press the POUND (#) button.
3. Press the plus (+) side of the VOLUME button.
4. Press the 0 number button.
5. Press the POUND (#) button.
The AUX mode button flashes three times.
6. Press the SAT mode button.
7. Press the plus (+) and minus (-) sides of the VOLUME
button.
The device’s volume changes and the AUX mode
button flashes instead of the TV mode button.
To set the remote back to control the TV volume :
1. Press and hold the TV mode button for three seconds, and then
release it. The TV mode button will flash.
2. Press the POUND (#) button.
3. Press the plus (+) side of the VOLUME button.