Dish Network 512 - Manual (Page 28)

Page 23
Remote Controls
Batteries
The remote controls come with AAA-size batteries, which need to be installed
when you first receive your system. When you replace old batteries, you should
replace all of the batteries. Use batteries of the same kind, for example alkaline
or lithium, and don’t mix batteries of different types or kinds. Lithium batteries
last longer than alkaline.
Installing or Changing the Batteries
1. Press down on the battery cover’s top latch and slide the
cover off.
2. If you are changing the batteries, take out all of the old
batteries.
3. Put the new batteries in. Make sure you match the plus
(“+”) ends with the plus markings on the battery case.
4. Slide the battery cover back into place.
Low Battery Warning
When you see a low-battery warning message below the Program Banner , the
batteries in your remote control are weak and need to be replaced.
Attach a UHF Antenna (for optional accessory)
You need to attach the UHF remote control antenna to
the receiver’s back panel R EMOTE A NTENNA
input if you
want to use an optional IR/UHF Pro remote control.
Note : Be sure to position this antenna straight up so you can use the remote
control from as far away as possible. Don’t let the antenna mast touch anything.