Dish Network 512 - Manual (Page 32)

Page 27
Changing the TV1 Output Channel
3. Press 0-0-0.
4. Press the POUND (#) button. The TV mode button flashes three
times.
Changing the TV1 Output Channel
The receiver comes preset to use channel 3 for TV1 coaxial output. If you are
experiencing interference on the channels you are using, follow these
instructions to change the channel that TV1 uses.
1. Press MENU-6-1-5 to open the Modulator Setup screen.
2. For the TV 1 Out , highlight the number under Channel .
3. Use the UP and DOWN ARROW buttons to change the modulator channel
either 3 or 4 .
4. Select Done to save the changes.
5. Change the channel on connected TV(s) to match the channel you selected.
6. If desired, to remind you of which TV channel to tune to get satellite
programming, place a channel sticker near or on your TV to indicate the
correct channel.
Connecting the Receiver to the Phone Line
You must keep the receiver connected to an active telephone line. Otherwise,
you may not be able to order pay-per-view programs, use all of the DISH Home
Interactive features, or access other customer services from DISH Network.
Make sure you are familiar with how to change channels on
your TV and if necessary how to switch your TV between
over-the-air and cable channels. When you change these
receiver output channels, you must also change the
channels on your TV(s) to tune to these channels to view
video from the receiver. See your TV’s user guide for
instructions.
Tip: When you
save the change to
your modulator
output channel,
always remember
to change the
channel on the
nearby TV to
match.
Tip: The channel
stickers are located
inside the front
cover of this guide.