Dish Network 512 - Manual (Page 92)

Page 87
Control Other Devices with the Remote Control
Scan for Device Codes
If the code for your device is not listed in the tables starting on page 109, use
this procedure to scan the remote control’s memory for a working device code.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
then stop here.
Sometimes the POWER or TV
POWER button works when other
buttons don’t. If the device does not
turn off, continue with step 10.
10. If the code doesn’t work, redo
steps 3 through 9 with another
device code from the tables.
Try every code listed for you brand
until one works best for your device.
11. For combination devices:
Return to step 3 and repeat
this procedure.
12. If you can’t find a code that
works, then try the Scan for
Device Codes that follows.
1. Turn the device on. Use the device’s front panel buttons
or its original remote control.
2. Press and hold the device
mode button until all the other
mode buttons light up, and
then release the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you
release the button, the TV mode
light will flash.
3. For AUX mode setup only.
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD player.
• Press 2 for a tuner or
audio amplifier.
This step is for specifying the kind
of device that is to be programmed
in AUX mode. If you’re not
programming in AUX mode, then
skip to step 5.
4. For AUX mode setup only:
Press the STAR (*) button.
5. Press the POWER button (not
TV Power).
This puts your remote control in its
device-code scan mode.