Montigo H34DL - Manual (Page 26)

H-Series DL Indoor Gas Fireplace
Page 26
XG0140 - 070714
Installation
Figure 31d. Front Left Log, (Log F).
Installing the Log set:
The H38DL* is supplied with a six ceramic fibre log logset. Unpack the
logs and handle them very carefully.
Step 1. Remove the glass door as described on Page 23.
Air Inlets
Pilot Assembly
Fireplace Base
Rear / Bottom Log
Notch in Log
Log A
Air Inlets
Fireplace Base
Log D
Figure 31b. Top Left Log, (Log D).
Air Inlets
Fireplace Base
Log E
Step 5. Place Front Left log (Log D) as shown in figure 31c.
Figure 31c. Top Right Log, (Log E)..
Step 6. Place Front Right log (Log E) as shown in figure 31e.
Fireplace Base
Log F
Air Inlets
Fireplace Base
Log C Log B
Step 7. Place Front Left log (Log F) as shown in figure 31f. Set notch
in lower end of Log F against stile on Log Grate.
Figure 31e. Completed Logset.
Figure 31. Bottom Rear Log, (Log A).
Step 2. Place the bottom Rear log (Log A) as shown in figure 31a.
Figure 31a. Left front Log, (Log C) and Right front Log, (Log B).
Step 3. Place the bottom Right log (Log B) and bottom Left Log, (Log
C) as shown in figure 31b.
If logs are not placed properly, excessive sooting will result.
NOTICE