NavCom StarFire to SW v3.0.12.0 - Manual (Page 2)

Troubleshooting Guide – Unable to Track StarFire After Updating to SW v3.0.12.0
Rev. A 2 Release – June 2012
5. Select ‘StarFire’ under ‘Detailed Views’.
6. Allow 3 minutes for receiver the to start tracking a StarFire Satellite. Click the ‘Refresh’ arrows one time
on the StarFire display. The StarFire Signal bar will display tracked signal strength. Typically 0-5dB/Hz is
considered weak, 5-8dB/Hz is normal, and 8>dB/Hz is Excellent.
7. Allow the receiver to navigate for a minimum of 1 hr 20 minutes to ensure it collects a new StarFire
almanac.