Nevion SDI-TD-MUX-4 - Manual (Page 26)

SDI-TD-MUX-4 / SDI-TD-DMUX-4 Rev. N
nevion.com | 26
Block Commands example Response Control
DMUX addresses:
0100-01FF: Serializer 1
0200-02FF: Serializer 2
0300-03FF: Serializer 3
0400-04FF: Serializer 4
0600-06FF: FPGA
0700-07FF: MCU EEPROM
0800-08FF: Deserializer
0900-09FF: LED
1000-10FF: FPGA program flash
rst <number> rst 1 ok <number>=0: Restarts all chips
except MCU and FPGA.
<number>=1: (DMUX only)
Restarts deserializer
<number>=2: Restarts MCU,
thereby reinitializing entire board.
<number>=4: Restarts FPGA only
wrr <address> <value> wrr 0x0679 1 ok Write to register. See description
of the ‘rdr’ command for valid
address ranges. Note that the
LEDs are read-only; all other
registers are writable, even if the
written value in some cases will be
overwritten almost immediately.