NIStune TYPE 1 V.3.5 - Manual (Page 24)

Nistune Type 1 Hardware Installation Page 24 of 33
6. Inserting the Board
Push the Nistune board into the machine drilled socket previously installed. Connect the CPU
cable to connector X1 and the USB cable to connector X2. If removing the board tilt slowly side to
side to avoid damaging the pins.
Ensure the PGM jumper is not soldered if the board was previously programmed. Where there is
a knock sensor board, being wary of the knock sensor cable
R31/Z31/VLT Installation
S13 CA18/M30 VG30/A31 RB30/S13 KA24E Installation