NIStune TYPE 1 V.3.5 - Manual (Page 8)

Nistune Type 1 Hardware Installation Page 8 of 33
To remove the two ROM chips (U3 and U4) desolder from the top side of the ECU. Be very
careful with the heat of the desoldering gun because the pads on these ECUs lift very easily. It
doesn't take much to break a track on these earlier circuit boards.
Insert the supplied IC socket in IC3 and solder in. Fill in the through holes if IC4 with solder.
Next remove the four brown jumpers. These are J4, J5, J8 and J10. You can shorten these
existing jumpers positions to J3, J6, J7 and J9 by desoldering one end and repositioning it. Be
careful when desoldering the track to ensure that it does not lift. These ECUs are very old and the
circuit boards are fragile.