Pacific Research Solutions RI-200 User Manual
Page 27
Pacific Research Solutions
RI-200 User Manual
Page 26
4.5.05
FORCE PTT ON
Keys up or “locks on” the repeater transmitter for the selected number of seconds. This provides a constant repeater
transmitter signal for running test, measuring power output, or checking signal coverage as you drive around. Once the timer
has expired, it will not reset itself. You can clear or reset this timer by entering a zero value for the time.
SYNTAX:
05 [Seconds]
MINIMUM:
0 (Reset timer)
MAXIMUM:
3600 Seconds (equals one hour max.)
UNITS:
Seconds
DEFAULT:
0
EXAMPLE:
05 120
Lock on the repeater transmitter for 120 seconds (2 minutes).
05 300
Lock on the repeater transmitter for 300 seconds (5 minutes)
4.5.06
REPEATER TELEMETRY MODE
CW telemetry is divided into 3 groups (ID, function complete/error and everything else including courtesy tones). This
command sets the CW telemetry responses to one of four modes. 1 - Everything Off, 2 - ID only, 3 - function complete & ID
only and 4 - all on. This command can be used to turn off the function complete and error messages while keeping the ID on.
If you omit the mode data, the controller will temporarily suspend the function complete or error message. This suspended
message is one time only, not effecting the previously selected mode. This feature can be used to keep a function complete
message from occurring during a macro or user command. More commonly used during an automatic command or scheduled
command.
SYNTAX:
06 [Mode]
MINIMUM:
(No Data)
MAXIMUM:
3 (All On)
UNITS:
Mode 0 = Everything off
Mode 1 = ID only
Mode 2 = ID, function complete and function errors only.
Mode 3 = All On
No data = Temporarily suspend function complete or function error.
DEFAULT:
Mode 3 = All On
EXAMPLE:
06 0
Turn off all telemetry responses
06 1
Turn on only the ID message.
4.5.07
ID INTERVAL TIMER
Select the time interval for the CW ID or station identification. The ID will try to be courteous in that it will wait for
someone to un-key before the controller sends the ID. A cleanup ID will also occur after the repeater activity has stopped and
the timer has elapsed.
SYNTAX:
07 [Time]
MINIMUM:
0 (Disable ID)
MAXIMUM:
255 (25.5 Minutes)
UNITS:
Tenths of Minutes
DEFAULT:
100 (10.0 Minutes)
EXAMPLE:
07 55
5.5 Minutes between IDs