Ri-200 repeater controller system command list – Pacific Research Solutions RI-200 User Manual
Page 80
Pacific Research Solutions
RI-200 User Manual
Page 79
RI-200 REPEATER CONTROLLER SYSTEM COMMAND LIST
System
Command
System Command Description
and Data Format
Command
Syntax
Factory
Setting
Pwr on
Recover
70
Telephone outgoing call mode
Mode, 0 = Disable AP, 1 = Simplex, 2 = Duplex
3 = Mute talk back, Simplex, 4 = Cover tone, Simplex
70 [Mode]
1
Simplex
Yes
71
Telephone incoming call mode
Mode, 0 = Disable, 1 = Delay - On-hook - Ring TX
2 = Delay - Off-hook- Ring TX
3 = Delay - Off-hook - Ring PW required to ring TX
4 = Delay - Off-hook Ring PW, CTCSS tone # and optional
DTMF string to ring TX (Tone and DTMF used during ring)
5 = Delay – Off-hook and connect telephone to repeater.
71 [Mode]
1
Yes
72
Telephone CTCSS/DCS tone panel enable
Mode 1 = Enable (on), 0 = Disable (off)
72 [Mode]
0
off
Yes
73
Telephone incoming call control time-out
DTMF inactive to on-hook
Time = 0 to 15 minutes, 0 = no time-out
73 [Time]
3
minutes
Yes
74
Telephone incoming call ring command and PW time-out
Time = 1 to 120 seconds
74 [Time]
30
seconds
Yes
75
Telephone incoming ring delay
Ring = 0 to 15
75 [Ring]
4
Rings
Yes
76
Telephone TX ring limit
Ring = 0 to 31, 0 = no limit
76 [Ring]
8
Rings
Yes
77
Telephone off-hook time-out
Time = 0 to 240 minutes, 0 = no time-out
77 [Time]
10
minutes
Yes
78
Telephone, no activity on RX time-out
Time = 0 to 240 seconds, 0 = no time-out
78 [Time]
60
seconds
Yes
79
Telephone AGC level set
Level = 0 to 7 (0 = AGC off)
79 [Level]
4
Yes
80
Flash hook switch
Used for call waiting and hold
80
N/A
N/A
81
Telephone dial tone/pulse select
Mode 0 = tone, 1 = pulse
81 [Mode]
0
tone
Yes
82
Telephone on/off-hook, access and account code
Code = 1 to 8 off-hook than code, 0 = on-hook,
9 = Answer ringing telephone
82 [Code]
N/A
No
83
Edit telephone access and account codes
Type 0 = Access, 1 = Account
Code = 1 to 8 memory location
Number = 0 to 16 digits
83 [Type] [Code]
[Number]
None
Yes
84
Telephone number auto-dial
Store = 00 to 99 memory location
Number = 0 to 16 digits (0-9, *, #, A = Pause)
No number to clear a memory location
*xx to recall stored number when dialing
*00 to recall last number radial
84 [Store]
[Number]
None
Yes
85
Set an auto-dial for use in a macro
Auto-Dial = 0 - 99
85 [Auto-Dial]
N/A
No