Pacific Research Solutions RI-200 User Manual
Page 43
Pacific Research Solutions
RI-200 User Manual
Page 42
SYNTAX:
52 [Item] [Value]
RANGE:
Item 1 = Upper threshold, Value range = 75 – 200
Item 2 = Lower threshold, Value range = 50 – 150
Item 3 = Acquisition time, Value range = 0 – 50 in 10 ms increments
Item 4 = Delay factor, Value range = 0 – 255
Item 5 = Average factor, Value range = 0 – 50
Item 6 = Weak signal threshold, Value range = 3 to 50 in 10 ms increments
UNITS:
Item 1 through 6, Value as listed in range.
DEFAULT:
Item 1 Upper threshold = 160
Item 2 Lower threshold = 130
Item 3 Acquisition time = 8 (80 ms)
Item 4 Delay factor = 125
Item 5 Average factor = 25
Item 6 Weak signal threshold = 5 (50 ms)
EXAMPLE:
52 1 200
Sets new squelch upper threshold value to 200
52 2 90
Sets new squelch lower threshold value to 90
4.5.53
RESERVED FOR FUTURE COMMAND
4.5.54
SET KEY-CODE FOR USER COMMANDS
The key-code is a 1 to 4 digit sequence that would be required in front of all user commands. This function could be used as a
site prefix so that all of your repeater sites would have the same user command suffix, while each site would have a distinctive
prefix. The KEY-CODE or PREFIX can be from 0 to 4 DTMF digits long, but C and D can not be used as digits in the key-
code. If zero key-code digits are entered in this command, the key-code function is disabled.
SYNTAX:
54 [Key-code]
MINIMUM:
0 digits (0 digits will disable the KEY-CODE)
MAXIMUM:
4 digits
UNITS:
DTMF digits 0 through 9, *, #, A and B
DEFAULT:
0 digits
EXAMPLE:
54
Disable the key-code.
54 *123
Sets *123 as the macro key-code or site prefix.
4.5.55
PASSWORD FOR S-COMMAND ACCESS
The PASSWORD is used to unlock the controller for access to the S-Commands. The factory default password is 123456 and
can be changed to another set of digits from 1 to 6 digits long. “C” is the only digit that can not be used in a password.
When selecting a password, you should avoid using one that is similar to a user command or the exact equivalent to an
S-Command and its data. For more information on passwords, see section 4.2 of this manual.
SYNTAX:
55 [Password]
MINIMUM:
1 digit
MAXIMUM:
6 digits
UNITS:
DTMF digits 0 through 9, *, #, A, B and D
DEFAULT:
123456
EXAMPLE:
55 34*685
The new password is now 34*685
55 12
The new password is now 12