Pacific Research Solutions RI-200 User Manual
Page 62
Pacific Research Solutions
RI-200 User Manual
Page 61
A message in the system memory is triggered by an event. Using S-Command 32, you can control which event will trigger or
start which message. Your pre-time-out event and post-time-out event can be set to trigger the same message. You may not
want the weak signal message, an easy way to disable it, is to point the weak signal event to the same message as the courtesy
message. You can also completely disable a message by pointing the trigger to start line 000.
5.5
EXITING PROGRAMMING MODE
Remember to execute an S-Command 69 to lock your controller when you are finished with the programming mode. The
controller will also exit the S-Command mode after 5 minutes of no DTMF activity. You may discover this by an automatic
function complete. Remember in the programming mode only S-Commands are functional. After exiting the programming
mode, only user commands are functional.